RX8 2004-2011: Intakes

RX8 HighFlow KandN Filter

The KandN Air Filter Element interchanges exactly with the stock paper element. It is constructed with cotton gauze material sandwiched between fine wire screening. This beautifully crafted filter is pre-oiled and ready for installation. This KandN filter comes with a Million Mile Warranty, and is certified to be street legal. KandN has done an outstanding job of supplying fully detailed instructions, a service record decal, and a warranty/registration card.

Customers who bought RX8 HighFlow KandN Filter also often bought:
	RX8 rear HPS HB378F.565 We are pleased to offer HAWK BRAKE streetable and race-application brake pads for a variety of Mazda street and motorsports activities. HAWK BRAKE is a leader in friction materials research and development for the automotive racing industry. HAWK BRAKE ... More Info
	Wilwood Brake Fluid::All Wilwood 570 Degree Brake Fluid,Wilwood's specially formulated Hi-Temp_ 570 Racing Brake Fluid has a minimum 570_ F dry bOiling point to withstand the severe heat requirements of automotive racing. Hi-Temp_ 570's low viscosity allows easy bleeding of your... More Info
	Hawk RX8 front HPS HB470F.643 for RX8 We are pleased to offer HAWK BRAKE streetable and race-application brake pads for a variety of Mazda street and motorsports activities. HAWK BRAKE is a leader in friction materials research and development for the automotive racing industry. HAWK BRAKE ... More Info

Installation Instructions

Re: Installing/upgrading Engine Mounts

Thanks to Cyberbug for his R&R tips, I was able to accomplish this quickly today and have a write-up here:http://www.billswebspace.com/miata.html ... ...
Posted by wrh3

Re: NC Coilover Install....OHLINS, JIC, etc...

Thank you morrisg. This is what I wanted to hear.
Posted by Burton

Re: NC Coilover Install....OHLINS, JIC, etc...

Sounds like you set the Ohlins up correctly with the 198mm measurement for the spring perch. If you are using the Ohlins supplied 4kg/mm springs for the rears...
Posted by morrisg

Re: Installing/upgrading Engine Mounts

I had only that day to work. The bolts in question (on top of the old mounts) can only be accessed with the car up on jackstands.Also, the lack of a suggested ...
Posted by hhowey

Re: NC Coilover Install....OHLINS, JIC, etc...

Quote:WARNING...you do NOT adjust height on the Ohlins or JIC by cranking the spring perches up against the spring tension and doing so can DAMAGE YOUR ...
Posted by Burton