CARBON FIBER Shroud for Racing Beat HighFlow Miata Intake :: 99-05

For use with the Racing Beat High Flow Miata Intake Assembly - 1999-05 Miata - ALL non-turbo models Racing Beat has developed a Cold Air Miata Intake system that is both functional and attractive! Intented to function with the Racing Beat High Flow Intake Assembly on all 1999-2004 non-turbo Miatas, this Cold Air Duct allows the intake to draw ONLY cooler ambient air into the intake duct.

Mazda placed a sizable opening in the area engine compartment just behind the driver-side headlamp. The inlet end of the RB High Flow Miata Intake was positioned almost directly over this opening. Each duct is produced from hand-laid fiberglass mat and finished with single layer of fiberglass backing.

The resulting product is a beautiful piece that is both strong and lightweight. Fitted to the exact contours of the engine compartment, and finished with an interlocking insulation trim, the precision fit of this Miata intake virtually eliminates the introduction of hot engine compartment air into the intake. As with all Racing Beat parts, extensive testing was done during the development of this Miata Intake. Prior to testing, a hole was drilled into the end of the KandN filter and a temperature sensor probe was inserted, which led to a digital temperature gauge that could be read in the cockpit. During test runs at 55 MPH (79 degrees ambient air temperature), intake air temperatures were recorded up to 15 degrees cooler inside the air filter with the carbon fiber shroud installed!

California Emissions Notice This Miata intake duct has received an emissions exemption from CARB (California Air Resource Board). Each Miata intake duct is supplied with a compliance decal which lists the applicable Executive Order number and the specific application. Simply install this decal under the hood of your car prior to your next tail pipe emissions test.

Price is for the carbon fiber duct ONLY, the High Flow Miata Intake is available separately