RX7 1979-1995: Wheels and Tires
Enkei RP-F1 18x9.5, 45mm offset 5x114
Customers who bought Enkei RP-F1 18x9.5, 45mm offset 5x114 also often bought: |
|
|
Hubcentric ring 73/67 Most modern aftermarket rims are made with an oversize center bore and the centering ring brings that bore size down to the RX7 hub fitment of 67.1mm. These are the rings for the Enkei wheels you see on this page for fitment of RX7 rims. Folks ask me all... More Info
|
|
Enkei Center Caps for RP-F1 These center caps are for 16 and 17 inch and 18 inch Enkei RP-F1 only! They do not make a center cap for the 15 inch size and these caps will NOT fit the 15 inch size. It is unfortunate that Enkei has gone to these very expensive fancy metal caps, we... More Info
|
|
McGard Spline Drive Lugs and Tool Set These are the patented design McGard Spline Drive lugs. Non-hex wheel lug which is both a light weight lug with more gripping surface area than the stock lug (to prevent lossening up under load), and a wheel lock. An RX7 takes 20 of these and ordering... More Info
|

Installation Instructions
Re: NC Header Installation
Another set of very complete installation instructions by a customer at Miata.net forum:http://forum.miata.net/vb/showthread.ph ... ost4703239
Posted by Brian
Re: AEM Install for NB
With Brian's help, I was able to get the nut off using some liquid wrench. Applied and let it sit for 4-6 hours, and used a vice grip wrench. Still took some...
Posted by Gecko
AEM with MonsterFlow coolbox Install for NB
Anyone else install the AEM short ram intake had trouble loosening the power steering pump nut? I am still not able to get it off and even took it to a shop ...
Posted by Gecko
Re: NC Goodwin trunk spoiler install
One other question:Is the spoiler made with polyester resin or epoxy resin? Apparently, that makes a difference when painting.Thanks
Posted by slartibartfast
Re: NC Header Installation
Brian,Great. Thanks for the info. As you may have guessed, I'm trying to plan out my next mods. It's tough, since I only have short periods of time to work ...
Posted by skeeler


First I want to again thank you for working with me on this muffler. I have almost 100 miles on it now, and it has a nice mellow sound. a little Bass, but not too much. A little louder than stock, but not too loud. Plus it is nice inside the car with the top up. I am happy so far I bought this one.
I belong to a local Miata club, and am very active with it. When Spring
comes I will tell everyone how much I like the muffler, and how great you
are to work with. Maybe I can get some extra business for you.
-- Bill







