MX5 2006-2012: Roll Bars

Silver Finish Upgraded Bar, Version 2! :: 06-12

NASA 1.75 Version!

Part Number: 30-10413

Application: 06-12

Price: $685.00

Quantity:

Built by our friends at AWR Racing (same company that makes the full cages for Mazda's Spec racing series with this same car!). When Mazda's own choice for building the full race Miata roll cage for the Miata builds a bolt in Miata bar, you can expect a great fit...and that's what we got when we installed this bar in our own 2006 MX5 Miata. Factory plastic simply snaps off and was out of the car in ten minutes, we had the factory bar out in another ten minutes, the new bar bolted in place in another 15 minutes, and were down to trimming and reinstalling factory plastic bits. Total install time about two hours with cleanup. Under the factory roll hoops is a wimpy factory bar that is remarkable only because it attaches in 6 different points, including all the way through to the pan.

This UPDATED VERSION NOW uses even much more stout 1.75in OD x .120 pursuant to the latest NASA rules (picture still shows older 1.5 tube size but the look is nearly the same...just a little thicker). Includes fully boxed steel cross section running between the seat belt towers to add a great deal of strength and superior protection, but still mounts to all the factory mounting points with all factory hardware for an easy installation! Made in silver finish or black powder coat as shown and includes a black fiberglass cap to make installation look almost factory (see full install instructions and pictures posted in our forum instruction section).

This is a direct bolt in roll bar with no drilling needed to install. This bar also comes with a black fiberglass cap for covering up the exposed trim left behind from original bar covers (look close in the picture). Bar is available in Black or Silver. Price includes shipping in the lower 48 states (we will cancel any ship charge our store adds for these orders). YES, still full function of the soft top and you can still use the optional factory hardtop. But, does not fit with Power factory folding hardtop.

Customers who bought Silver Finish Upgraded Bar, Version 2! :: 06-12 also often bought:
	McGard Spline Drive Lugs and Tool Set These are the patented design McGard Spline Drive lugs. Non-hex wheel lug which is both a light weight lug with more gripping surface area than the stock lug (to prevent lossening up under load), and a wheel lock. An MX5 takes 20 of these and ordering... More Info
	Enkei 17x9 RP-F1, 45mm offset 5x114, 15.9 pounds This Enkei 17x9 RP-F1 is our TOP wheel choice for MX5 Miata track and autocross! Includes Enkei Aluminum Valve Stems! Nothing else comes close to this combination of ultra light weight and strength (Rolling Rim technology used to make these rims... More Info
	Hubcentric Ring set to Fit Miata 72.62mm/54 Most modern aftermarket rims are made with an oversize center bore and the centering ring brings that bore size down to the Miata hub fitment of 54.1 mm. If you have a Miata, these help properly fit your new alloys. Price is for set of FOUR... More Info