Miata 1990-2005: Interior : Braces

Autopower Seat Brace For 1.5 inch tubing

This easy to adjust seat support brace meets SCCA requirements. It bolts to the horizontal tube of your rollbar or roll cage with no welding required. Pick the brace for 1 1/2" tubing or 1 3/4ths.

Customers who bought Autopower Seat Brace For 1.5 inch tubing also often bought:
	Enkei 17x9.5 RP-F1, 38mm offset 5x114 Nothing else comes close to this combination of ultra light weight and strength (Rolling Rim technology used to make these rims results in grain alignment just like in forged wheels for greater strength than is available from mere cast wheels but at much... More Info
	Westco 12V31M Miata Battery The Westco Miata battery utilizes absorbed glass mat technology for approximately 30% more cranking amps than a stock Miata battery. With this latest design, terminal location is OEM correct and installation of this Miata battery is easy. FED EX Ground... More Info
	ULTRA Spark Plug Wires::90-93 ULTRA 8mm Red Hot Ignition Wire Sets utilize silicone rubber for both the 8mm wire insulation and boots, with a minimum rating of 100,000 volts in all areas. The silicone rubber is designed to withstand continuous temperatures ranging from -60 degrees F... More Info

Installation Instructions

Re: Installing/upgrading Engine Mounts

Thanks to Cyberbug for his R&R tips, I was able to accomplish this quickly today and have a write-up here:http://www.billswebspace.com/miata.html ... ...
Posted by wrh3

Re: NC Coilover Install....OHLINS, JIC, etc...

Thank you morrisg. This is what I wanted to hear.
Posted by Burton

Re: NC Coilover Install....OHLINS, JIC, etc...

Sounds like you set the Ohlins up correctly with the 198mm measurement for the spring perch. If you are using the Ohlins supplied 4kg/mm springs for the rears...
Posted by morrisg

Re: Installing/upgrading Engine Mounts

I had only that day to work. The bolts in question (on top of the old mounts) can only be accessed with the car up on jackstands.Also, the lack of a suggested ...
Posted by hhowey

Re: NC Coilover Install....OHLINS, JIC, etc...

Quote:WARNING...you do NOT adjust height on the Ohlins or JIC by cranking the spring perches up against the spring tension and doing so can DAMAGE YOUR ...
Posted by Burton