Miata 1990-2005: Wheels and Tires: Wheels
BLACK Heliums, 15x6.5 40mm Offset--11.4 Pounds SALE
Customers who bought BLACK Heliums, 15x6.5 40mm Offset--11.4 Pounds SALE also often bought: |
|
|
Hubcentric Ring set to Fit Miata 73/54 Most modern aftermarket rims are made with an oversize center bore and the centering ring brings that bore size down to the Miata hub fitment of 54.1 mm. If you have a Miata, these help properly fit your new alloys. Price is for set of FOUR rings. More Info
|
|
Helium Center Caps-- Snap on caps for Heliums, also fits Konig Minuz....and can be adapted to Enkei RP-F1 15 inch size only. Only in silver (they don't make a bronze cap). Note the picture is old, the current cap is ROUND. Price is per cap. More Info
|
|
McGard Spline Drive Lugs and Tool Set These are the patented design McGard Spline Drive lugs. Non-hex wheel lug which is both a light weight lug with more gripping surface area than the stock lug (to prevent lossening up under load), and a wheel lock. A Miata takes 16 of these and ordering... More Info
|

Installation Instructions
Re: NC Header Installation
Another set of very complete installation instructions by a customer at Miata.net forum:http://forum.miata.net/vb/showthread.ph ... ost4703239
Posted by Brian
Re: AEM Install for NB
With Brian's help, I was able to get the nut off using some liquid wrench. Applied and let it sit for 4-6 hours, and used a vice grip wrench. Still took some...
Posted by Gecko
AEM with MonsterFlow coolbox Install for NB
Anyone else install the AEM short ram intake had trouble loosening the power steering pump nut? I am still not able to get it off and even took it to a shop ...
Posted by Gecko
Re: NC Goodwin trunk spoiler install
One other question:Is the spoiler made with polyester resin or epoxy resin? Apparently, that makes a difference when painting.Thanks
Posted by slartibartfast
Re: NC Header Installation
Brian,Great. Thanks for the info. As you may have guessed, I'm trying to plan out my next mods. It's tough, since I only have short periods of time to work ...
Posted by skeeler







