Mazda3 2005-2010: Wheels and Tires
Hubcentric Ring set to Fit Mx5 73/67
Customers who bought Hubcentric Ring set to Fit Mx5 73/67 also often bought: |
|
|
McGard Spline Drive Lugs and Tool Set These are the patented design McGard Spline Drive lugs. Non-hex wheel lug which is both a light weight lug with more gripping surface area than the stock lug (to prevent lossening up under load), and a wheel lock. An RX8 takes 20 of these and ordering... More Info 
|
|
Forged Team Dynamics Lug Nuts For the totally fanatical about unsprung weight we bring you the lightest lug nuts you will ever hold in your hand. 25 of these weigh a grand total of half a pound. Note that you should not use an air gun on forged aluminum lugs, hand tighten only. So... More Info
|
|
Enkei RP-F1 17x9, 45mm offset 5x114, 15.9 pounds Aggressive choice for the Mazda3 owners out there. Nothing else comes close to this combination of ultra light weight and strength (Rolling Rim technology used to make these rims results in grain alignment just like in forged wheels for greater strength... More Info
|
Installation Instructions
Re: NC Header Installation
Another set of very complete installation instructions by a customer at Miata.net forum:http://forum.miata.net/vb/showthread.ph ... ost4703239
Posted by Brian
Re: AEM Install for NB
With Brian's help, I was able to get the nut off using some liquid wrench. Applied and let it sit for 4-6 hours, and used a vice grip wrench. Still took some...
Posted by Gecko
AEM with MonsterFlow coolbox Install for NB
Anyone else install the AEM short ram intake had trouble loosening the power steering pump nut? I am still not able to get it off and even took it to a shop ...
Posted by Gecko
Re: NC Goodwin trunk spoiler install
One other question:Is the spoiler made with polyester resin or epoxy resin? Apparently, that makes a difference when painting.Thanks
Posted by slartibartfast
Re: NC Header Installation
Brian,Great. Thanks for the info. As you may have guessed, I'm trying to plan out my next mods. It's tough, since I only have short periods of time to work ...
Posted by skeeler
