Miata 1990-2005: Brakes : Hydraulics

Mazda REBUILT Brake Calipers RIGHT REAR :: 90-93

Finding replacement calipers has always been a hassle. In the past the quality of rebuilt units was always suspect, or worse yet, scouring salvage yards for used ones. Mazda rebuilt calipers take the hassle and guess work out of replacing your calipers. You are insured a quality rebuild and better yet, there are no cores to return, simply purchase and install. Due to manufacturing dates and raw materials available the casting color may vary. Calipers sold individually and are not loaded.

Customers who bought Mazda REBUILT Brake Calipers RIGHT REAR :: 90-93 also often bought:
	MAZDA Miata REBUILT Replacement Brake Calipers LEFT REAR::90-93 Finding replacement calipers has always been a hassle. In the past the quality of rebuilt units was always suspect, or worse yet, scouring salvage yards for used ones. Mazda rebuilt calipers take the hassle and guess work out of replacing your calipers.... More Info
	McGard Spline Drive Lugs and Tool Set These are the patented design McGard Spline Drive lugs. Non-hex wheel lug which is both a light weight lug with more gripping surface area than the stock lug (to prevent lossening up under load), and a wheel lock. A Miata takes 16 of these and... More Info
	Enkei Center Caps for RP-F1 These center caps are for 16 and 17 inch Enkei RP-F1 only! They do not make a center cap for the 15 inch size and these caps will NOT fit the 15 inch size. It is unfortunate that Enkei has gone to these very expensive fancy metal caps, we are passing... More Info

Installation Instructions

Re: Installing/upgrading Engine Mounts

Thanks to Cyberbug for his R&R tips, I was able to accomplish this quickly today and have a write-up here:http://www.billswebspace.com/miata.html ... ...
Posted by wrh3

Re: NC Coilover Install....OHLINS, JIC, etc...

Thank you morrisg. This is what I wanted to hear.
Posted by Burton

Re: NC Coilover Install....OHLINS, JIC, etc...

Sounds like you set the Ohlins up correctly with the 198mm measurement for the spring perch. If you are using the Ohlins supplied 4kg/mm springs for the rears...
Posted by morrisg

Re: Installing/upgrading Engine Mounts

I had only that day to work. The bolts in question (on top of the old mounts) can only be accessed with the car up on jackstands.Also, the lack of a suggested ...
Posted by hhowey

Re: NC Coilover Install....OHLINS, JIC, etc...

Quote:WARNING...you do NOT adjust height on the Ohlins or JIC by cranking the spring perches up against the spring tension and doing so can DAMAGE YOUR ...
Posted by Burton