Miata 1990-2005: Wheels and Tires : Wheels

NEW...Konig ReTrack 15x7, 40mm, 4x100 Graphite

Another great choice from Konig...13.4 pounds for the 15x7 size! Works great for supporting some of our wider tire choices. Stock Miata offset for 15 inch wheels was 40mm...and so are these...Yet with deep machined lip for an updated look

Fits ALL 1990 through 2005 Miatas...and even fits our big brake kits. Takes a standard 73/54 hubcentric ring always available on this website. Includes Center Caps!

BOXED IN PAIRS...so please order 2 or 4....not one.

Customers who bought NEW...Konig ReTrack 15x7, 40mm, 4x100 Graphite also often bought:
	McGard Spline Drive Lugs and Tool Set These are the patented design McGard Spline Drive lugs. Non-hex wheel lug which is both a light weight lug with more gripping surface area than the stock lug (to prevent lossening up under load), and a wheel lock. A Miata takes 16 of these and... More Info
	Hubcentric Ring set to Fit Miata 73/54 Most modern aftermarket rims are made with an oversize center bore and the centering ring brings that bore size down to the Miata hub fitment of 54.1 mm. If you have a Miata, these help properly fit your new alloys. Price is for set of FOUR rings. More Info
	Racing Beat Type II Wing::99-05 The Type II Rear Wing adds an aggressive edge to the Mazda s latest Miata. Manufactured in the USA using hand-laid fiberglass mat and easily prepped for final painting, the Type II Rear Wing readily attaches to the trunk lid with a simplified hardware... More Info

Installation Instructions

Re: Installing/upgrading Engine Mounts

Thanks to Cyberbug for his R&R tips, I was able to accomplish this quickly today and have a write-up here:http://www.billswebspace.com/miata.html ... ...
Posted by wrh3

Re: NC Coilover Install....OHLINS, JIC, etc...

Thank you morrisg. This is what I wanted to hear.
Posted by Burton

Re: NC Coilover Install....OHLINS, JIC, etc...

Sounds like you set the Ohlins up correctly with the 198mm measurement for the spring perch. If you are using the Ohlins supplied 4kg/mm springs for the rears...
Posted by morrisg

Re: Installing/upgrading Engine Mounts

I had only that day to work. The bolts in question (on top of the old mounts) can only be accessed with the car up on jackstands.Also, the lack of a suggested ...
Posted by hhowey

Re: NC Coilover Install....OHLINS, JIC, etc...

Quote:WARNING...you do NOT adjust height on the Ohlins or JIC by cranking the spring perches up against the spring tension and doing so can DAMAGE YOUR ...
Posted by Burton