Miata 1990-2005: Exhaust : Headers

Header Gasket 99-05

Header Outlet Gasket 99-05 This do-nut gasket is used between the Racing Beat header and the factory connecting pipe on the 1999-05 Miata. (This gasket has a larger ID than the factory gasket that would normally be used at this connection.)

Customers who bought Header Gasket 99-05 also often bought:
	Quality Rubber Shift Boot - Large--::90-05 Torn rubber shift boots allow fumes and extra noise into the interior. If you have noticed a change for the worse in your Miata it is time to change one or both of the factory boots. The smaller, lower boot, sits on top of the transmission at the... More Info
	PowerFlex High Temp POLYURETHANE Exhaust Hangers::90-05 Factory exhaust hangers are made from a rubber compound containing natural products, which deteriorates with age. The bushings become softer and more pliable, and therefore becoming less capable of resisting the forces being placed on them. These... More Info
	Racing Beat Sway Bar Endlinks -::99-05 rear These Racing Beat-designed links are a direct swap with the Miata factory units and provide the performance enthusiast the ability to set either front or rear sway bars to a "neutral position" while the chassis is at ride height to avoid pre-loading of... More Info

Installation Instructions

Re: Installing/upgrading Engine Mounts

Thanks to Cyberbug for his R&R tips, I was able to accomplish this quickly today and have a write-up here:http://www.billswebspace.com/miata.html ... ...
Posted by wrh3

Re: NC Coilover Install....OHLINS, JIC, etc...

Thank you morrisg. This is what I wanted to hear.
Posted by Burton

Re: NC Coilover Install....OHLINS, JIC, etc...

Sounds like you set the Ohlins up correctly with the 198mm measurement for the spring perch. If you are using the Ohlins supplied 4kg/mm springs for the rears...
Posted by morrisg

Re: Installing/upgrading Engine Mounts

I had only that day to work. The bolts in question (on top of the old mounts) can only be accessed with the car up on jackstands.Also, the lack of a suggested ...
Posted by hhowey

Re: NC Coilover Install....OHLINS, JIC, etc...

Quote:WARNING...you do NOT adjust height on the Ohlins or JIC by cranking the spring perches up against the spring tension and doing so can DAMAGE YOUR ...
Posted by Burton