Miata 1990-2005: Radiators, Cooling : Hoses and Belts

Miata Radiator Hose Kit by Mishimoto, RED :: 90-97

Mishimoto silicone Miata radiator hose kits are made with a dual layer combining high grade silicone and heat-resistant embedded fibers to provide efficient heat reduction and increased pressure tolerance, all with an OEM replacement fit! Perfect for your Mazda Miata.

* Interior Material: Heat-Resistant Embedded Fibers
* Exterior Material: Silicone
* Max Temperature: 330 F
Available for 1990-1997 Mazda Miata models.

Purchase Includes: Mishimoto upper and lower silicone radiator hoses.

Customers who bought Miata Radiator Hose Kit by Mishimoto, RED :: 90-97 also often bought:
	Quality Rubber Shift Boot - Small::90-05 Torn rubber shift boots allow fumes and extra noise into the interior. If you have noticed a change for the worse in your Miata it is time to change one or both of the factory boots. The smaller, lower boot, sits on top of the transmission at the... More Info
	Quality Rubber Shift Boot - Large--::90-05 Torn rubber shift boots allow fumes and extra noise into the interior. If you have noticed a change for the worse in your Miata it is time to change one or both of the factory boots. The smaller, lower boot, sits on top of the transmission at the... More Info
	Koyo Performance Radiator Cap Koyo designs its radiators to take all factory spec parts which means your factory cap will fit, and your factory plug will fit, and your factory fans will bolt right on. But for those who want an upgraded new cap to go with their new Miata Koyo... More Info

Installation Instructions

Re: Installing/upgrading Engine Mounts

Thanks to Cyberbug for his R&R tips, I was able to accomplish this quickly today and have a write-up here:http://www.billswebspace.com/miata.html ... ...
Posted by wrh3

Re: NC Coilover Install....OHLINS, JIC, etc...

Thank you morrisg. This is what I wanted to hear.
Posted by Burton

Re: NC Coilover Install....OHLINS, JIC, etc...

Sounds like you set the Ohlins up correctly with the 198mm measurement for the spring perch. If you are using the Ohlins supplied 4kg/mm springs for the rears...
Posted by morrisg

Re: Installing/upgrading Engine Mounts

I had only that day to work. The bolts in question (on top of the old mounts) can only be accessed with the car up on jackstands.Also, the lack of a suggested ...
Posted by hhowey

Re: NC Coilover Install....OHLINS, JIC, etc...

Quote:WARNING...you do NOT adjust height on the Ohlins or JIC by cranking the spring perches up against the spring tension and doing so can DAMAGE YOUR ...
Posted by Burton