RX8 2004-2011: Suspension

H. Powerflex Polyurethane Bushings - Rear Sway Bar - Pair 16mm

H. Powerflex Polyurethane Bushings - Rear Sway Bar - Pair. Powerflex polyurethane bushings are 25%-30% stiffer than the factory bushings and do not deteriorate in performance over time. The benefit of the increased stiffness is superior control of the suspension components giving you more control over your RX8. Make sure you have the factory rear 16mm sway bar BEFORE you order.

Customers who bought H. Powerflex Polyurethane Bushings - Rear Sway Bar - Pair 16mm also often bought:
	Racing Beat MX5 Sway Bar Endlinks FRONT::2006-2012 Racing Beat Sway Bar End Link Set for all 2006-2012 MX-5 and 2004-2012 RX-8 FRONT sway bar applications. These sway bar end links are direct replacements for the stock RX-8 and MX-5 end links. The Racing Beat sway bar end link set can is fully adjustable... More Info
	Enkei RP-F1 18x9.5, 45mm offset 5x114 Lighter and less expensive than SSRs in this size at only 17.4 pounds for 9.5 inches wide and this special order from Enkei in the 45mm offset FITS all four corners of your RX8. Don't be fooled into running the staggered front and rear wheel sizes so... More Info
	C. Powerflex Polyurethane Bushings - Front Sway Bar - Pair 26.5 mm Item C ONLY in the picture!! Powerflex polyurethane bushings are 25%-30% stiffer than the factory bushings and do not deteriorate in performance over time. The benefit of the increased stiffness is superior control of the suspension components giving you... More Info

Installation Instructions

Re: Installing/upgrading Engine Mounts

Thanks to Cyberbug for his R&R tips, I was able to accomplish this quickly today and have a write-up here:http://www.billswebspace.com/miata.html ... ...
Posted by wrh3

Re: NC Coilover Install....OHLINS, JIC, etc...

Thank you morrisg. This is what I wanted to hear.
Posted by Burton

Re: NC Coilover Install....OHLINS, JIC, etc...

Sounds like you set the Ohlins up correctly with the 198mm measurement for the spring perch. If you are using the Ohlins supplied 4kg/mm springs for the rears...
Posted by morrisg

Re: Installing/upgrading Engine Mounts

I had only that day to work. The bolts in question (on top of the old mounts) can only be accessed with the car up on jackstands.Also, the lack of a suggested ...
Posted by hhowey

Re: NC Coilover Install....OHLINS, JIC, etc...

Quote:WARNING...you do NOT adjust height on the Ohlins or JIC by cranking the spring perches up against the spring tension and doing so can DAMAGE YOUR ...
Posted by Burton