MX5 2006-2012: Wheels and Tires : Wheels

NEW Enkei PF01 18x8, 40mm, 5x114

Another super LIGHT and STRONG Miata Enkei wheel. Note that if you use stock lugs on this wheel you WILL SCRATCH IT UP badly because of the narrow and deep socket pockets on this design. Therefore, we STRONGLY recommend our McGard Spline drive two piece lugs or, our Team Dynamics forged lugs, with this wheel. Center caps and racing valve stems included with this Enkei Wheel. Takes a 75/67mm hubcentric ring available separately on the website.

Customers who bought NEW Enkei PF01 18x8, 40mm, 5x114 also often bought:
	NEW Enkei PF01 18x9.5, 45mm, 5x114 Another super LIGHT and STRONG Miata Enkei wheel. Note that if you use stock lugs on this wheel you WILL SCRATCH IT UP badly because of the narrow and deep socket pockets on this design. Therefore, we STRONGLY recommend our McGard Spline drive two piece... More Info
	Enkei GTC01 18x7.5---48mm....NEW! Another NEW ultra light and strong MX5 Miata wheel from Enkei. This rim is formed my "MAT-DURA FLOW FORMING" which creates a grain alignment similar to forging but at lower cost. The result is both super light and yet ultra stiff and strong. Gorgeous... More Info
	Enkei GTC01 18x8---48mm....NEW! Another NEW ultra light and strong MX5 Miata wheel from Enkei. This rim is formed my "MAT-DURA FLOW FORMING" which creates a grain alignment similar to forging but at lower cost. The result is both super light and yet ultra stiff and strong. Gorgeous... More Info

Installation Instructions

Re: Installing/upgrading Engine Mounts

Thanks to Cyberbug for his R&R tips, I was able to accomplish this quickly today and have a write-up here:http://www.billswebspace.com/miata.html ... ...
Posted by wrh3

Re: NC Coilover Install....OHLINS, JIC, etc...

Thank you morrisg. This is what I wanted to hear.
Posted by Burton

Re: NC Coilover Install....OHLINS, JIC, etc...

Sounds like you set the Ohlins up correctly with the 198mm measurement for the spring perch. If you are using the Ohlins supplied 4kg/mm springs for the rears...
Posted by morrisg

Re: Installing/upgrading Engine Mounts

I had only that day to work. The bolts in question (on top of the old mounts) can only be accessed with the car up on jackstands.Also, the lack of a suggested ...
Posted by hhowey

Re: NC Coilover Install....OHLINS, JIC, etc...

Quote:WARNING...you do NOT adjust height on the Ohlins or JIC by cranking the spring perches up against the spring tension and doing so can DAMAGE YOUR ...
Posted by Burton