Miata 1990-2005: Interior : Dashboard

Dash Panel Cubby - Cubby Only :: 90-97

Are you considering an aftermarket radio for your MkI Miata, and you are hesitant because of the gaping hole that will be left in your dash? Have you already replaced the radio and you're tired of looking at that gap? These dash panel cubbies plastic is formulated to be a perfect match to your existing factory pieces.

NOTE: Fits single DIN radios only.

Customers who bought Dash Panel Cubby - Cubby Only :: 90-97 also often bought:
	Interior Light Kit - Black Console::90-95 More light for dark nights. Factory original appearance with replaceable 5-watt bulbs for strong illumination. These lights easily wire into existing lights. Detailed instructions included. TWO lights included (one for both foot well area). More Info
	Racing Beat Rear Chassis Brace The Racing Beat-design Rear Lower Control Arm Brace is intended for 1990 through 1991 1/2 Miata chassis. This brace will also fit the 1999-05 Miata chassis with no modifications required. While it can be installed on other Miata chassis, substantial... More Info
	Miata Oil Pressure Gauge Kit 95-05 In 1995 Mazda changed the Miata oil pressure gauge into a go/no-go gauge indicator. By replacing the sender to a voltage signal you can have real oil pressure readings! This Miata Oil Pressure Kit requires adjusting the pointer on the factory gauge. Kit... More Info

Installation Instructions

Re: Installing/upgrading Engine Mounts

Thanks to Cyberbug for his R&R tips, I was able to accomplish this quickly today and have a write-up here:http://www.billswebspace.com/miata.html ... ...
Posted by wrh3

Re: NC Coilover Install....OHLINS, JIC, etc...

Thank you morrisg. This is what I wanted to hear.
Posted by Burton

Re: NC Coilover Install....OHLINS, JIC, etc...

Sounds like you set the Ohlins up correctly with the 198mm measurement for the spring perch. If you are using the Ohlins supplied 4kg/mm springs for the rears...
Posted by morrisg

Re: Installing/upgrading Engine Mounts

I had only that day to work. The bolts in question (on top of the old mounts) can only be accessed with the car up on jackstands.Also, the lack of a suggested ...
Posted by hhowey

Re: NC Coilover Install....OHLINS, JIC, etc...

Quote:WARNING...you do NOT adjust height on the Ohlins or JIC by cranking the spring perches up against the spring tension and doing so can DAMAGE YOUR ...
Posted by Burton