Thank you. You have rated this product.
The EcuTek ProEcu Programming kit is hardware only, and allows you to flash your car using Moto East tunes, or later on, tunes from another tuner should you switch makes or have a setup not supported by Moto East. Please note that this does not allow DIY editing; but only the flashing of supplied tunes. This is also a full featured datalogger(requires a laptop with a USB drive.)
Note that this is for NON-COMMERCIAL use and CANNOT BE SHIPPED TO AUSTRALIA OR JAPAN AT THIS TIME. NOT CARB APPROVED, CANNOT SHIP TO RESIDENTS OF CALIFORNIA.
This includes: Custom Tuning-
Basic Normally Aspirated Tuning (includes license)
HOW DOES THE PROCESS WORK? Instructions included but process is very simple. We send you the box with cable to attach a notebook computer to the car OBDII outlet, and a separate USB Dongle that contains the license. You start by downloading the software to your computer from the Ecutek site. Then you use that software with the cable and USB Dongle to download ('Ecu Dump') the calibration that is in your car from Mazda (over 2 dozen factory calibrations so this step tells the tuner which is actually in your Miata). You send that downloaded calibration by email to Mike at Motoeast and he sends back modified calibration for upload back into the car. After loading the modified calibration you do some driving with the notebook computer attached to the OBDII outlet to log how the car responds to the changes and send Mike that log. Mike has done so many that usually just one round of this process is needed but if going E85 or other more specialized tunes then a few rounds of the log and load calibration process may be required before the tune is dialed in just right.