Miata 1990-2005: Exhaust : Mufflers

Borla Stainless Steel Cat-Back Miata Exhaust System : 90-97

The Borla name is synonymous with performance exhaust. This Miata exhaust system commands attention under acceleration and mellows out under normal driving. Installation is easy and straightforward. 50-state emissions legal with a 1-million mile warranty. Fits manual transmission only. Polished Stainless Steel Tip.

Note that because this Miata exhaust has NO resonator in the midpipe and the resulting sound level of this Miata exhaust is VERY sporty.

Customers who bought Borla Stainless Steel Cat-Back Miata Exhaust System : 90-97 also often bought:
	McGard Spline Drive Lugs and Tool Set These are the patented design McGard Spline Drive lugs. Non-hex wheel lug which is both a light weight lug with more gripping surface area than the stock lug (to prevent lossening up under load), and a wheel lock. A Miata takes 16 of these and... More Info
	Racing Beat Front Miata Sway Bar Tubular::90-93 Our favorite Miata sway bar....Racing Beat-designed Miata sway bars reduce chassis roll in turns and increase your Miata's sensitivity to steering inputs, thereby improving maximum cornering power. This 1-1/8-inch OD tubular Miata sway... More Info
	Factory Shock Boot - Standard Rear PAIR::90-93, 94-97 You have the shocks and springs all picked out and you're looking forward to getting them installed. The last thing you want to do is compromise your new set up by installing old, torn and damaged, shock boots. Debris on the shaft of the shock can be... More Info

Installation Instructions

Re: Installing/upgrading Engine Mounts

Thanks to Cyberbug for his R&R tips, I was able to accomplish this quickly today and have a write-up here:http://www.billswebspace.com/miata.html ... ...
Posted by wrh3

Re: NC Coilover Install....OHLINS, JIC, etc...

Thank you morrisg. This is what I wanted to hear.
Posted by Burton

Re: NC Coilover Install....OHLINS, JIC, etc...

Sounds like you set the Ohlins up correctly with the 198mm measurement for the spring perch. If you are using the Ohlins supplied 4kg/mm springs for the rears...
Posted by morrisg

Re: Installing/upgrading Engine Mounts

I had only that day to work. The bolts in question (on top of the old mounts) can only be accessed with the car up on jackstands.Also, the lack of a suggested ...
Posted by hhowey

Re: NC Coilover Install....OHLINS, JIC, etc...

Quote:WARNING...you do NOT adjust height on the Ohlins or JIC by cranking the spring perches up against the spring tension and doing so can DAMAGE YOUR ...
Posted by Burton