Miata 1990-2005: Exhaust : Catalytic-Converter

RoadsterSport High Performance Miata Catalytic Converter-FEDERAL Version : 94-97

RoadsterSport High Performance replacement catalyst for your Miata at one third of the cost of the smaller diameter dealer units.

YES, EPA legal converter core (EPA 94106).

YES, includes gaskets and hardware needed for installation in your Miata!

Yes, 2.5 inch stainless pipe and laser cut flanges!

Yes, bolt holes are slotted so you can squeeze this 2.5 inch diameter unit into the factory space... but it has the flow for use with any of our performance Miata exhausts from RoadsterSport to Racing Beat, Borla, etc.

Customers who bought RoadsterSport High Performance Miata Catalytic Converter-FEDERAL Version : 94-97 also often bought:
	Racing Beat Miata Header::94-97 Our favorite Miata header for normally aspirated Miatas, consistently outperforms the Jackson Header and for less money. Manufactured entirely from 304-stainless steel for superior durability, this 4:1 Miata header is sure to offer many years of... More Info
	NEW...COMPLETE Cat-Back RoadsterSport 3 Miata Polished Stainless Steel Exhaust for 90-97 It is BACK! By popular demand we once again have a RoadsterSport exhaust for 90-97 Miatas! Includes the connecting pipe! We took the RoadsterSport 3 features of our 99-05 design and applied them to a complete redesign of our exhaust for 90-97... More Info
	Quality Rubber Shift Boot - Large--::90-05 Torn rubber shift boots allow fumes and extra noise into the interior. If you have noticed a change for the worse in your Miata it is time to change one or both of the factory boots. The smaller, lower boot, sits on top of the transmission at the... More Info

Installation Instructions

Re: Installing/upgrading Engine Mounts

Thanks to Cyberbug for his R&R tips, I was able to accomplish this quickly today and have a write-up here:http://www.billswebspace.com/miata.html ... ...
Posted by wrh3

Re: NC Coilover Install....OHLINS, JIC, etc...

Thank you morrisg. This is what I wanted to hear.
Posted by Burton

Re: NC Coilover Install....OHLINS, JIC, etc...

Sounds like you set the Ohlins up correctly with the 198mm measurement for the spring perch. If you are using the Ohlins supplied 4kg/mm springs for the rears...
Posted by morrisg

Re: Installing/upgrading Engine Mounts

I had only that day to work. The bolts in question (on top of the old mounts) can only be accessed with the car up on jackstands.Also, the lack of a suggested ...
Posted by hhowey

Re: NC Coilover Install....OHLINS, JIC, etc...

Quote:WARNING...you do NOT adjust height on the Ohlins or JIC by cranking the spring perches up against the spring tension and doing so can DAMAGE YOUR ...
Posted by Burton