RX8 2004-2011: Clutch, Flywheel, Drivetrain

Racing Beat RX8 Aluminum Flywheel and Counterweight

From street to road racing, the Racing Beat Aluminum Flywheel is ideally suited for a wide range of performance applications. This lightweight aluminum unit reduces the flywheel weight about 29 percent from the original, and reduces the flywheel inertia. Includes BOTH the flywheel AND the counterweight.

The kit Aluminum Flywheel Kit includes the correct Mazda rear balance weight and all the hardware necessary for installation,

Customers who bought Racing Beat RX8 Aluminum Flywheel and Counterweight also often bought:
	Wilwood Brake Fluid::All Wilwood 570 Degree Brake Fluid,Wilwood's specially formulated Hi-Temp_ 570 Racing Brake Fluid has a minimum 570_ F dry bOiling point to withstand the severe heat requirements of automotive racing. Hi-Temp_ 570's low viscosity allows easy bleeding of your... More Info
	RX8 rear HPS HB378F.565 We are pleased to offer HAWK BRAKE streetable and race-application brake pads for a variety of Mazda street and motorsports activities. HAWK BRAKE is a leader in friction materials research and development for the automotive racing industry. HAWK BRAKE ... More Info
	Hawk RX8 front HPS HB470F.643 for RX8 We are pleased to offer HAWK BRAKE streetable and race-application brake pads for a variety of Mazda street and motorsports activities. HAWK BRAKE is a leader in friction materials research and development for the automotive racing industry. HAWK BRAKE ... More Info

Installation Instructions

Re: Installing/upgrading Engine Mounts

Thanks to Cyberbug for his R&R tips, I was able to accomplish this quickly today and have a write-up here:http://www.billswebspace.com/miata.html ... ...
Posted by wrh3

Re: NC Coilover Install....OHLINS, JIC, etc...

Thank you morrisg. This is what I wanted to hear.
Posted by Burton

Re: NC Coilover Install....OHLINS, JIC, etc...

Sounds like you set the Ohlins up correctly with the 198mm measurement for the spring perch. If you are using the Ohlins supplied 4kg/mm springs for the rears...
Posted by morrisg

Re: Installing/upgrading Engine Mounts

I had only that day to work. The bolts in question (on top of the old mounts) can only be accessed with the car up on jackstands.Also, the lack of a suggested ...
Posted by hhowey

Re: NC Coilover Install....OHLINS, JIC, etc...

Quote:WARNING...you do NOT adjust height on the Ohlins or JIC by cranking the spring perches up against the spring tension and doing so can DAMAGE YOUR ...
Posted by Burton