Miata 1990-2005: Interior : Shift-Knobs-Boots

Voodoo Knob Magnum Spun Finish : All

Shifting pleasure....good fit. Note that we only sell the "magnum" version of the round which is not as big as it sounds and has the right weight to work just right. This picture compares pearl on the left with SPUN on the right.

Customers who bought Voodoo Knob Magnum Spun Finish : All also often bought:
	McGard Spline Drive Lugs and Tool Set These are the patented design McGard Spline Drive lugs. Non-hex wheel lug which is both a light weight lug with more gripping surface area than the stock lug (to prevent lossening up under load), and a wheel lock. A Miata takes 16 of these and... More Info
	Quality Rubber Shift Boot - Large--::90-05 Torn rubber shift boots allow fumes and extra noise into the interior. If you have noticed a change for the worse in your Miata it is time to change one or both of the factory boots. The smaller, lower boot, sits on top of the transmission at the... More Info
	Quality Rubber Shift Boot - Small::90-05 Torn rubber shift boots allow fumes and extra noise into the interior. If you have noticed a change for the worse in your Miata it is time to change one or both of the factory boots. The smaller, lower boot, sits on top of the transmission at the... More Info

Installation Instructions

Re: Installing/upgrading Engine Mounts

Thanks to Cyberbug for his R&R tips, I was able to accomplish this quickly today and have a write-up here:http://www.billswebspace.com/miata.html ... ...
Posted by wrh3

Re: NC Coilover Install....OHLINS, JIC, etc...

Thank you morrisg. This is what I wanted to hear.
Posted by Burton

Re: NC Coilover Install....OHLINS, JIC, etc...

Sounds like you set the Ohlins up correctly with the 198mm measurement for the spring perch. If you are using the Ohlins supplied 4kg/mm springs for the rears...
Posted by morrisg

Re: Installing/upgrading Engine Mounts

I had only that day to work. The bolts in question (on top of the old mounts) can only be accessed with the car up on jackstands.Also, the lack of a suggested ...
Posted by hhowey

Re: NC Coilover Install....OHLINS, JIC, etc...

Quote:WARNING...you do NOT adjust height on the Ohlins or JIC by cranking the spring perches up against the spring tension and doing so can DAMAGE YOUR ...
Posted by Burton