Miata 1990-2005: Interior

Hardtop Brackets-ALUMINUM

Mandated safety equipment if you are building a Spec Miata, these brackets bolt your hardtop to your chassis. Made from lightweight .125 thick ALUMINUM and powdercoated black, the front brackets are etched to show the correct side for installation, all hardware is included.

SOLD OUT and replaced by stronger STEEL version.

Customers who bought Hardtop Brackets-ALUMINUM also often bought:
	Axxis/PBR ULT Ultimates---OUT OF STOCK::01-05 Sport Suspension FRONT PBR ULT Miata Brake Pads, also known as Axxis Ultimates, are quickly developing a loyal following in the Miata community because they have one of the highest coefficients of friction of any brake pad available for street use on the market. Anything higher... More Info
	Porterfield R4S - STREET Rear::94-00 The "S" is for street. These are an old favorite of mine. They work great for street/autocross and light track duty. Most track days this is what I have in the rear of my 99 track toy. They dust a bit but the performance is consistent from street... More Info
	Custom Driver's Side Miata Seat Rail for RACE SEATS.::1990-2005 Finally, a convenient way to get a race seat into your NA/NB. Driver's side only! NOT a general purpose mount!!! These are custom made to match the holes in the floor of your NA/NB Miata which mount your factory seat. These make race seats a bolt in! ... More Info

Installation Instructions

Re: Installing/upgrading Engine Mounts

Thanks to Cyberbug for his R&R tips, I was able to accomplish this quickly today and have a write-up here:http://www.billswebspace.com/miata.html ... ...
Posted by wrh3

Re: NC Coilover Install....OHLINS, JIC, etc...

Thank you morrisg. This is what I wanted to hear.
Posted by Burton

Re: NC Coilover Install....OHLINS, JIC, etc...

Sounds like you set the Ohlins up correctly with the 198mm measurement for the spring perch. If you are using the Ohlins supplied 4kg/mm springs for the rears...
Posted by morrisg

Re: Installing/upgrading Engine Mounts

I had only that day to work. The bolts in question (on top of the old mounts) can only be accessed with the car up on jackstands.Also, the lack of a suggested ...
Posted by hhowey

Re: NC Coilover Install....OHLINS, JIC, etc...

Quote:WARNING...you do NOT adjust height on the Ohlins or JIC by cranking the spring perches up against the spring tension and doing so can DAMAGE YOUR ...
Posted by Burton