Custom Miata Seat Rail for RACE SEATS....PASSENGER SIDE : 1990-2005

Finally, a convenient way to get a race seat into your NA/NB. PASSENGER SIDE only! NOT a general purpose mount!!! These are custom made to match the holes in the floor of your NA/NB Miata which mount your factory seat. These make race seats a bolt in! They are pre-drilled for Sparco mounts/sliders but can be adapted to most race seats. Includes hardware for use with SPARCO mounts including special clearance nuts and more.

BRIAN'S APPLICATION NOTES: In case it is not obvious from the photo above, the item is sent bare steel so that you have the option of welding to it. That means it may get a petina of rust in transit and you should expect to clean it up with a little steel wool on arrival in preparation for a quick coat of spray paint before installation. Typical options that customers weld to the rail are eyes for harness clip in. Most drivers use these with a combination of ALL THREE of the following: Sparco seats, Sparco side mounts, and Sparco sliders (rails are pre-drilled for sliders). In my own Miata I skip the slider because that gets me another half inch lower in the car but that meant I drilled additional holes to get the side mounts directly onto these rails.