Thank you. You have rated this product.
Nothing else comes close to this combination of ultra light weight and strength (Rolling Rim technology used to make these rims results in grain alignment just like in forged wheels for greater strength than is available from mere cast wheels but at much lower cost than forged wheels).
Takes a 73/67 ring for those that want the hubcentric rings, available elsewhere on the website.
YES, despite what some other retailers are telling customers, these RPF1 wheels WILL TAKE YOUR STOCK TPMS tire pressure sensors! Narrow extended length lugs are recommended (see McGard Spline Drive lugs here on our website).
The Enkei Most Advanced Technology (M.A.T) process combines one-piece cast wheel technology with a rim forming spinning process. Using this rim forming M.A.T process improves material strength dramatically as compared with normal cast wheels. Rim-Rolled technology shapes the rim to improve material elongation without sacrificing the wheels hardness.
All Enkei wheels are engineered to pass rigorous testing. In fact, Enkei established its own test standard called "Spec-E," which is tougher than JWL requirements. The Enkei Spec-E test setting requires a higher drop point in the impact test and 20% more cycles for the rotary bending fatigue and dynamic radial fatigue tests than JWL standards. The Spec-E represents Enkei confidence in its technology and quality of Enkei wheels. YES, fits our Wilwood Big Brake Kits. Picture of SBC Finish 48mm offset 17x7.5, 5x114, with 235/40/17 tires courtesy of customer Maury Fugitt
On Customer Car Below with 215/45/17
On Our Own 2012 PRHT Project Car Below with 215/45/17