Karcepts Front Sway Bar Kit - 1.25 O.D. x 0.095 Wall for Fiat-124
Images may differ from actual product appearance.

Karcepts Front Sway Bar Kit - 1.25" O.D. x 0.095" Wall



PART NUMBER: 61-2069F2


Price: $600.00



Free shipping offers apply only to destinations within US Lower 48.

Price: $600.00



Free shipping offers apply only to destinations within US Lower 48.


Designed for the most serious competitors, the Karcepts Front Sway Bar Kit leaves no compromises on the table. Hundreds of hours of design time have gone into this kit utilizing CMM technology and FEA analysis. The end result is a Front Sway Bar Kit that offers super quick adjustability, an enormous adjustment range, maximum stiffness with minimal weight, and an installation time of just 30 minutes (after the stock bar has been removed).

  • Sway bar rate is adjusted with one wrench, in only a few minutes
  • Rate adjustments are made with the vehicle on the ground, even at low ride heights
  • 5 adjustment positions per sway bar arm, maximizing tunability and overall range
  • Billet aluminum arms optimized for strength and weight utilizing the latest FEA software
  • Light weight, zero deflection solid sway bar mounts provided for precise feel
  • Low friction, lubrication free, dirt resistant, solid polymer bearings require no maintenance
  • Heat treated and plated steel alloy PTFE lined endlinks and all hardware included
  • 1.25" diameter high-grade spring steel splined center section for consistent rates

Sway Bar Rates:

OEM ND Front Sway Bar = 132 lbs/in

Karcepts ND Front Sway Bar Kit - 1.25" O.D. x 0.095" Wall:

Hole 1/1 = 361 lbs/in

Hole 1/2 = 382 lbs/in

Hole 2/2 = 403 lbs/in

Hole 2/3 = 428 lbs/in

Hole 3/3 = 453 lbs/in

Hole 3/4 = 483 lbs/in

Hole 4/4 = 513 lbs/in

Hole 4/5 = 549 lbs/in

Hole 5/5 = 585 lbs/in

Kit Weight = 8.6 lbs

Center Section Recommendations: This is Brian's choice for C Street autocross here; more rotation, less understeer, lots of top CS results and several top PAX in our ND2 CS car.

View the installation instructions for any potential install/fitment questions you may have:KFSB-ND-XX Installation Instructions

Brian's Application Notes: I admired and admired this setup but we did not start to carry it until I watched an STR competitor change both his front and rear sway bar settings BETWEEN RUNS at an SCCA event. Took him under a minute to change the rear sway setting, and just over a minute at the front...which is amazing. No other sway setup empowers you to change settings as fast as this setup in my experience, making this setup unique for the hardcore racers who want to dial their setup on the fly.

IMPORTANT FITMENT NOTES: These do NOT fit Fiat 124 without some help. The OEM intercooler tubing has two bolts to a bracket that need to be removed, then the tubing can be shifted around to gain enough clearance for the bar. The OEM intercooler stays in place. Install in our Fiat 124 was easy, no issues with the aftermarket EC upgraded intercooler using silicon tubes.