PART NUMBER: 61-2197
Reduces under-hood pressure by 50%
Dramatic Improvement in engine cooling efficiency
Decreases lift on the front of the car
Backed by data developed through pressure and flow testing
Outperforms every hood vent option tested (by a lot)
Specifically designed for the ND Miata hood
Retains hood rigidity and the use of the stock hood latch
Designed and produced in the USA
Hoods vents are a key element to improving the cooling system effectiveness. Reducing the pressure behind the radiator creates a larger differential between the front and rear of the radiator. The larger the pressure differential, the greater the airflow through your radiator. Reducing underhood pressure also cuts down on lift under the front of the car, improving downforce.
These louvers work in the lightweight factory aluminum hood to minimize cost and you do not have to deal with poor fitment of aftermarket hoods, and does not sacrifice hood rigidity so that even the stock hood latch can still be used.
This is a DIY installation part. That said, Singular MotorSports gave careful thought to ease of install from the beginning and you get a full vinyl cutting template specific to the ND Miata. The cut template removes the guesswork from your install, just stick it on and it shows you where to cut. Also included is rubber trim that fits around the circumference of the holes, making it easy to achieve a clean and finished look.
Installation note: There is a step-by-step hood louver installation guide on the Singular Motorsports website. Note that guide follows the install of a set of NA hood louvers on the 1st generation car, but the guide still serves to show the installation steps which apply to all generations of MX5. The only thing the changes is the specific measurements/placement of the cut templates. For the ND, template placement is as follows:
- Front edges of the holes in-line with each other and about 10.75" behind the front edge of the hood.
- 12" width between the inner-most corners of the two holes.
The louvers ship flat (unbent), you bend the fins when you receive them. The louvers come anodized in black, and can easily be painted over if you desire a different color.
What you get:
Precision waterjet aluminum louvers
Aluminum rivet mounting hardware
Rubber trim to cover the cut edge for a clean look
Pair of vinyl cut templates.
The Louvers are well made and the end result serves a purpose and looks great. The installation its tedious and should be done by a professional... the rivets need to be painted body color. I used Black rivets to match the gloss black that I painted the louvers.
Want to Review This Product?
(You must be logged in as a Good-Win-Racing Member. Join Now. It's Free!)