Sparco Seat Base - Left Side (Driver side in LHD)
There are many ways to mount your Sparco seats, depending on application.
This is the BOTTOM BASE BRACKET ONLY. This base mounts to the factory holes in the car and give you somewhere flat to mount the upper portion of a seat bracket to. You will need side brackets in addition to this base bracket, and you can also optionally add a Sparco slider as well - which would mount in between your base bracket and the side mounts.
SPECIAL ORDER FROM SPARCO, allow 2-3 weeks!
NOTE: These sit rather high, see our PCI Seat Brackets for something that sits flush to the floor and gets your aftermarket seat as low as possible. BUT the PCI brackets are not compatible with a slider, so if you want a slider then you will need to go this route with Sparco base, slider, and side brackets, and understand that you will not be as low.