Racing Beat Sway Bar Endlinks -Rear

DESCRIPTION

From Racing Beat: These Racing Beat-designed links are a direct swap with the Miata factory units and provide the performance enthusiast the ability to set either front or rear sway bars to a "neutral position" while the chassis is at ride height to avoid pre-loading of the bar.

The experienced enthusiast may wish to purposely "pre-load" the bar to create a specific handling characteristic to induce either a mild understeer or oversteer condition. The CNC-machined aluminum end housings are fitted with urethane bushings to further reduce flexing - as compared to stock rubber bushing links.

Each set contains two (2) links to serve one (1) sway bar. These links have been designed for use on all Mazda and Racing Beat sway bars. Sold by the pair.

Our notes: These endlinks are the simplest type, with just a through-bolt and a bushing at each end, so they are the most budget-friendly endlink we offer. However, the sway bar and the mounting tabs on the control arms are not directly in-line with each other, so there is some misalignment that the endlinks need to accommodate. This type of endlink doesn't have any way to do that, so to install them you have to flex the bushings hard and force the endlink to a position where the bolts will go in. We strongly recommend considering one of the other many endlinks we offer that have either heim joints or ball joints at the ends, which can pivot and allow for that misalignment without putting extra stress on the endlinks and mounting points.