PART NUMBER: 60-1095NC
These PowerFlex EXH-005 Polyurethane bushings on the other hand are 25%-30% stiffer and do not deteriorate in performance over time. The benefit of the increased stiffness is superior control of the exhaust...preventing knocks that might otherwise occur with your stock hangers. Sold individually. Use a bit of lube on these to slide them on and keep some lube on them (unlike rubber these need some lube or you risk tearing them).
MIATA MX5-NC 2006-2015
MIATA MX5-NC 2006-2015
MIATA MX5-NC 2006-2015
While installing my new header and mid-pipe, I found one of the stock hangers to be quite deteriorated and starting to split. It ripped completely open while removing. Ran to Autozone to get a cheap generic replacement just so I could drive the car with new exhaust, but I wasn't going to settle for that cheap stuff. Called my local Mazda dealer for replacement and after 10 minutes, the parts guy finally tells me that it's not a stock part and I'd have to order with a lead time of 3-5 days.....just one reason why I despise most dealerships! So I could wait a week for stock rubber or within the same time, I could have polyurethane hangers from Goodwin. 5 days later i spent 15 minutes replacing all the hangers. Super easy with dish soap and two screwdrivers. Much stiffer and looks like they should last much longer! Don't swap out your exhaust without ordering them first!
Please buy these when changing out your muffler or midpipe. Make sure to use some lubricant before you start the installation.
These small items definitely are a must when replacing/upgrading the older exhaust. The stock rubber was sagging as well as allowing muffler swing on hard cornering. These new units removed the sag, and also got rid of the muffler sway. Definitely worth the money.
Great fix for the sagging rubber hangers. Only needed three, as I replaced the factory muffler with a Roadster Sport single outlet street muffler 1 1/2yrs ago. Hangers are a bugger to install. Had to use hight temp grease and a clamp to get them on, but once there, they proved fantastic.. Highly recommended.
Don't overlook these if you are doing an exhaust upgrade! Did a full Goodwin exhaust install recently (Dec 2013) and replaced the stock rubber hangers with these polyurethane ones. They are so much firmer than the factory rubber. Four for the muffler and one for the mid-pipe...it's worth the the extra $50 or so.
Want to Review This Product?
(You must be logged in as a Good-Win-Racing Member. Join Now. It's Free!)