PART NUMBER: 61-2037C
Direct replacement for your factory plastic coolant expansion tank. Made in the USA, all aluminum with beautiful TIG welding. Constructed with internal baffles and a machined aluminum neck that takes a factory cap. All of the inlets and outlets are positioned to match up with the factory hoses. The tank mounts to the same location as the factory tank and is built with the same dimensions for an easy fit. Includes view window on the side to check fluid level.
Option is to add a high performance CSF 20psi radiator cap. These tanks are compatible with the factory cap, so replacing the cap is not mandatory, but if you need a replacement for your used factory cap then this is the best option!
NEW optional satin black powdercoated finish offers a more subtle option than the bare aluminum. The satin black is a low-gloss finish that looks right at home in the NC engine bay, unlike a wrinkle or high gloss black that matches nothing around it. Some other examples of powdercoated tanks done by individuals or other shops make the mistake of coating the nipples where hoses and cap attach. That is a no-no! This premium powdercoating is done at the factory the correct way with all critical areas properly masked so that you get a great looking finish without compromises.
As these cars age, the factory plastic tank is a common failure point because the plastic gets brittle and cracks. Unlike the earlier cars where that just meant a leak, the NC relies on this tank to be a pressurized part of the cooling system, which means that as soon as a crack forms the system loses pressure and the engine overheats. We've had more and more people bring in cars with blown motors due to this simple failure, and along with a new expansion tank now they need a new motor as well, so we decided it was time for a "lifetime" solution. This tank is the solution. It will not fail over time like the factory tank, and looks great as well!
CLAMPS: While the factory squeeze-clamps on the hoses can be re-used, they get weaker the more they are removed/installed and having a tight seal on all the hoses is important since this tank is pressurized. We recommend changing the squeeze clamps out for worm drive hose clamps which can be found at any auto parts store. #4 worm clamp (x2) for the top two nipples, #10 worm clamp (x1) for the bottom.
CAP: You might need to very slightly adjust the 'tangs' on the factory radiator cap to fit the new metal neck with same tension as it did on the factory softer plastic neck, takes a few seconds to do with pair of needle nose pliers.
Great write-up of the install process over on the Revlimiter blog: