Replacement bleeder for Wilwood calipers

DESCRIPTION

For Wilwood calipers ONLY. Not for factory Mazda calipers.

Sold INDIVIDUALLY

Fits: Dynalite 4 piston, Dynapro 4 and 6 piston, Superlight 4 and 6 piston, and more Wilwood calipers.
Does NOT fit the Powerlite 4 piston rear caliper.

Wilwood s individual bleed screws and bleed screw kits are manufactured to high quality standards. These premium grade fittings have been designed for use in repair and maintenance of your Wilwood calipers.

Install note: These new fittings have new sealant on the threads, but if there's any brake fluid trapped in the threads when you install the new fitting, the brake fluid can prevent the sealant from sealing properly, resulting in a leak. So when replacing the fitting, it's important to ensure there is no brake fluid in the threads. To do that, remove the caliper from the vehicle, remove the bleeder fitting, and drain the caliper completely of brake fluid. Then use water to dissolve any brake fluid in the threads, and ensure the threads are completely dry before installing the new fitting (also make sure the caliper is completely dry inside). You can use compressed air to speed up the drying before you install the new fitting.