Flow Force 640cc Injectors

DESCRIPTION

New v2.0 kit includes specially designed fuel rail spacers and upgraded connectors!

Cutting edge Bosch EV14 technology

Flow matched within +/-1% static and dynamic (2ms pulse, idle conditions) flow rates for a smooth idle even on small engines

Multi-hole tip for superb atomization

Works with multiple fuel types, including E85

Plug and Play Connectors, or pigtails
NOTE: "Plug and Play" means these plug right in to the factory fuel injector connectors, no wiring needed. This does NOT mean you can just run them on the factory ECU tune. You MUST re-tune for larger injectors.
These EV14 injectors are the go-to choice for high performance naturally aspirated builds, low pressure e85 forced induction, or light built motor pump gas force induction. Thanks to our tight flow matching at 2ms pulse width, they will support 300whp on pump gas, and still idle beautifully.

Kit Includes:

4x 640cc Flow Matched EV14 Injectors
4x Denso to USCAR connector plugs, or USCAR pigtails
4x Denso bottom cushions
4x 12mm top hat extenders (import fit, 11mm diameter)
3x 2.5mm fuel rail spacers
1x dielectric grease

Bosch Type IV Fuel Injector Info:

This is a high performance, high volume fuel injector. Fuel delivery is from a multi-hole disc which incorporates a wide cone-shape spray pattern for maximum fuel atomization for modern single-valve and multi-valve engines. These injectors will function at fuel rail pressures of up to 7 bar.

Length: 2-3/8 inches, 64 mm; 48mm O-ring to O-ring
Diameter: 9/16 inches, 14 mm
Resistance: 14.5 Ohms (high resistance)
Electrical connector type: USCAR, EV6

Installation Notes:
You must have an aftermarket ECU to install these injectors.