SuperPro Offset Bushings +/- 0.5 degrees

DESCRIPTION

SuperPro offset bushings replace your front/upper/inner control arm bushings with offset design, allowing you to add MORE CAMBER than you can get with factory bushings.

Location: Front
Suspension Type: Double Control Arm
NOTES: Adds +/- 0.5 degrees

BRIAN'S APPLICATION NOTES: Mazda did a fantastic job of making the MX5's and RX8's setup adjustable, and you do get progressively more negative camber as you lower the car. Normally we lower the car between one and two inches and we get some more negative camber from that, but often not as much as we need. We use these on every racing NC we have, the secret to over 3 degrees negative front camber at reasonable heights. And customers who want to stay at stock height range but want enough negative camber for spirited driving can get an extra half degree of camber with these. Alternatively, some folks want to lower the car substantially and therefore have too much camber for tire longevity and in that case you can use these to allow you to dial back half a degree of negative camber for LESS camber than factory bushings.

SuperPro products are formed using their own engineered product designs and are made using a proprietary engineering grade polyurethane formula with unique material properties. SuperPro Polyurethane is a special elastomer based material which gives an extremely durable suspension product boasting the best characteristics of both rubber and plastic.